|
Model: ChuggerHead - $50+
In addition of the full line of Chugger Pumps, we also offer the two stainless pump heads as replacement/retrofit items. These are fully functional heads that will bolt directly on to any chugger motor housing and March 809s providing an inexpensive means to turn a plastic pump into stainless.
316 Stainless Steel (Rear Housing), Teflon (Thrust Washer), CLEAR Silicone (O-Ring), POLYSULFONE (Impeller)
Can handle liquids of 250F
Materials are FDA Food Compliant
Components are UL Recognized
DO NOT RUN DRY |
Approx. Ship. Weight(LBS) : 1
|
| |
Differences (as chosen in the dropdown below):
- The stainless INLINE head has both have 1/2" male NPT on the inlet and outlet. (shown on the bottom right picture)
- The stainless center inlet head has a 3/4" NPT male on the center inlet and a 1/2" male NPT on the outlet. (shown on the top right picture)
Both types are in stock right now.
Some notes on using mag drive pumps:
These are not self priming pumps. The pump head must be flooded with liquid prior to turning the pump on. The easiest way to do this is to let liquid fill the inlet hose prior to connecting it to the pump. If the pump squeels or makes loud noises, shut it down and make sure the head is full of liquid.
If you wish to regulate the flow rate, it must be done on the output side of the pump.
Use teflon tape on all threaded connections and be very careful not to cross thread when applying metal fittings to the polysulfone heads. Stripping or cross-threading the polysulfone or galling the threads on the stainless head is not covered under warranty.
|
