Return to Spincycle Robo, Whirlpool Return for Robobrew Pumped Units

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

2 of 2 people found the following review helpful:

Can use with grainfather March 1, 2021 Reviewer: Zer0 from Salt Lake City, UT United States   Works with grainfather that has been camlock converted if you're willing to bend the SS tubing slightly. Was this review helpful to you?

0 of 0 people found the following review helpful:

Works great on the Brewzilla 65L September 23, 2019 Reviewer: Brian Miller from Laguna Hills, CA United States   I just brewed with this and it worked great! The included camlock fitting worked perfectly with the whirlpool arm. If you have an immersion chiller make sure the cold water goes to the bottom of the chiller first for optimal chilling speed. Was this review helpful to you?

0 of 0 people found the following review helpful:

Great product September 19, 2019 Reviewer: Dennis ONeill from Reading, PA United States   The whirlpool arm looks well made connects to the existing cam lock a little tight but fits they also added a matched set of cams if your cam doesn’t work can’t wait to do a run and test it out. The delivery was quick and well packed thanks guys two thumbs up will shop here again Was this review helpful to you?

1 of 1 people found the following review helpful:

Does not fit my Robobrew V3 March 27, 2019 Reviewer: Anonymous Person from Oakland, CA United States   ******************* Brewhardware.com Response: We have sold 100 of these so far and the reports of non-compatibility with the Cam D that is preinstalled on the ROBO is in the single digits. This suggests that there is an issue with the Cam D where the units female/male are a matched pair but perhaps without regard to the Mil-Spec standard. We've decided to force the issue by including a new Cam D to ensure compatibility. Was this review helpful to you?

1 of 1 people found the following review helpful:

February 24, 2019 Reviewer: Thomas Manning from grayslake, IL United States   Works great, does exactly what it’s intended to do Was this review helpful to you?

0 of 0 people found the following review helpful:

Great Service and it works February 16, 2019 Reviewer: Andrew Tompkins from Derbyshire, United Kingdom   The only issue is that my robobrew v3's manifold won't lock closed onto the whirlpool attachment.  I use a cable tie to hold the locking arms together.  I understand from others that it can be machined down further until it fits properly but I don' t have the tools to do this. It might even be improved further if the end of the pipe was restricted so that it forces the liquid out at higher velocity causing more spin.  Guess I could do this myself with a hammer! Was this review helpful to you?

0 of 0 people found the following review helpful:

Had the same issue with CamLock February 1, 2019 Reviewer: GregK from Cranberry Twp, PA United States   I had the same issue with adding a connection other than the arm that came with it, I ended up replacing the Type D - Female QD Coupling to Female 1/2" NPT ($5.65)with a new one and now all my other connections fit like a charm including the arm that came with the unit. easy fix and now I cam seamlessly connect my wert chiller or recirculation arm. hope it helps Was this review helpful to you?

0 of 0 people found the following review helpful:

Nice but the cam fitting is too big to lock down January 25, 2019 Reviewer: John Rager from Maidens, VA United States   It is a nice product but the cam fitting is too wide in the center and needs sanding down to allow the cam lock arms to fully close to lock it in place. I used a Dremel like tool to carefully remove enough material to allow the cam lock arms to fully close. Was this review helpful to you?