Return to EVAbarrier tubing, 4mm ID X 8mm OD (5.5ft length)

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

May 3, 2023 Reviewer: Jacob Schray from Wind Gap, PA United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

September 6, 2022 Reviewer: Akocs Christopher from Clifton, NJ United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

May 23, 2022 Reviewer: Roger Hanson from Plymouth, MN United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

No regrets! April 7, 2022 Reviewer: Richard Turchi from Keaau, HI United States   The EVAbarrier 4mm tubing is working perfectly for both the gas and liquid lines.   The psi is set at 12  and pours have never been  better.  And using Duotight push-fit fittings to tie everything together made the switchover super easy. Was this review helpful to you?

0 of 0 people found the following review helpful:

Just what I needed. November 15, 2020 Reviewer: Kenneth Galipeau from Hackettstown, NJ United States   Just what I needed to transfer beer between kegs. Was this review helpful to you?

0 of 0 people found the following review helpful:

Nice tubing April 6, 2020 Reviewer: Robert Schweitzer from Smithtown, NY United States   I was using Accuflex tubing in my kegerator but it was way too stiff.  This tubing is A LOT MORE flexible and I was able to reuse all of the fittings! Was this review helpful to you?

0 of 0 people found the following review helpful:

great tubing January 31, 2020 Reviewer: Ronald Crabb from Minooka, IL United States   The tubing is as advertised but the advice to place it in boiling water for 2 minutes to get it on a 1/4" barb was a bust.  The tubing melted. Was this review helpful to you?

0 of 0 people found the following review helpful:

The hype is real January 19, 2020 Reviewer: Edward Gierlach from Dacula, GA United States   Upgraded from my old 3/16 ID Micro Matic  beverage lines. In combination with the push fittings, this is an easy install/upgrade. If you have a 2.5-3” Tower and your shanks have a barb, you’ll want to warm the end of the line in some hot water and flare the end to get it to easily slip onto the barb. (I used a metal ballpoint pen). I think for most applications the 5.5ft of line will be perfect. (I may knock of a half foot to help speed up pours) You will notice a new and improved taste to the beer when you switch to these lines! Was this review helpful to you?

0 of 0 people found the following review helpful:

Nice draft system tubing November 8, 2019 Reviewer: Eric from NY United States   I replaced all the beer and gas PVC tubing with the 4mm and replaced all my barb fittings with the push to fit fittings.  Tubing and push to fits are very easy to work with.  I'm running 7' lines and get great pour at 12-14 PSI in 39F keezer.  Am convinced the barrier is protecting from oxygen as the first ounce of the first pour of the day tastes just as good as the next. Was this review helpful to you?