Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Hop Bong Dry Hopper FULL Kit - 2" reduced for 1.5" Fermenter Port $149.99
Oxebar Tapping Head for PET Keg $15.99
Corny Keg Diptube Oring, BLACK, Pair $0.99
Beer Thread Low Profile 90 (5/8" BSP Street Elbow) 304SS $9.99
Silicone Tubing, Made in USA, 3/4" ID x 1" OD (Standard 1/8" Thick Walls) PER FOOT $3.69
Butterfly Valve, Squeeze Trigger, SS LIGHTWEIGHT, 1.5" TC ports $55.00
Blichmann BrewCommander Temperature Sensor Bulkhead (RP-081-00) $16.00
Spike 10gal Plus False Bottom (TC pickup tube) $137.50
BrewBuilt® Insulated Tubing Kit for X-Series Jacketed Conicals $163.00