Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Hose Barb, 1/4" Female NPT x 1/4" Hose ID $3.00
Quick Disconnects (BLQD) - FQD x 1/4" Compression $16.00
Challenger Hop Pellets, 8 OZ $13.19
Make Weldless Kit 1/2" NPT, For Thermowells $5.00
Pressure Transfer Kit, Carboy to Corny Keg, Economy $16.00
East Kent Golding EKG (GB) Hop Pellets 1 oz $2.31
Buon Vino Super Jet Filter Pads - 3-pack Fine (Number 2) $6.99
1.5 TC EPDM Gasket with 10 Mesh Screen $7.99
Bru-1 Hop Pellets, LB $25.30