Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Sparkolloid 1oz - Wine Clarifier Finings $2.92
BrewBuilt® Insulated Tubing Kit for X-Series Jacketed Conicals $163.00
Fermaid-O Organic Yeast Nutrient - 12 gram bag $3.29
Belgian Bottle Cork 44 x 25.5 mm 30 count $11.99
Aromatic Malt, Dingemans LB $2.64
Tube Cleaning Brush, 1/4" diameter, 66" long $7.99
Honey, Buckwheat, One Pound $9.89
Wine Corks, #9 Premium Synthetic closure , 100 count $24.99
Flare Washer, 1/4 Nylon $0.25