Make Weldless Kit 1/4" NPT for COOLERs

Home > Equipment > Keg, Pot, Cooler Parts >

Our Price: $7.00

Quantity in Stock:13

Product Code: MWL14COOLER

Qty:

Description

If you want to install a dial thermometer in a double wall cooler, you'll need an extended bulkhead like these. Here's how they work: The dial thermometer threads directly into the open end of the coupling. The coupling extends through the outside wall and insulation of the cooler and then the weldless bushing/gasket seals to the interior wall of the cooler. This 1/4" NPT version requires a 3/4" hole in the outside wall of the cooler and a 1/2" hole in the interior wall. The weldless bushing piece in this assembly is custom machined just for us so this isn't something that can be easily made from "off the shelf" parts.

Keep in mind that this bulkhead is NOT meant for draining liquid out of your cooler.

The picture below shows the application of this bulkhead for use with a dial thermometer. The picture shows both available sizes. BE VERY CAREFUL WITH THE SIZES OF HOLES REQUIRED ON THE INSIDE AND OUTSIDE WALLS OF THE COOLER.

Average Rating: Average Rating: 5 of 5

5 of 5 Total Reviews: 1 Click Here to Write a Review »

0 of 0 people found the following review helpful:

	Wednesday, September 19, 2018
Reviewer: David Kilgore from Jenison, MI United States

Was this review helpful to you?

	CaraAroma, Weyermann OZ $0.14
	Flaked Barley OZ $0.14
	SSbrewtech Silicone Rubber Kettle Pad for 20 gallon kettles $21.95