Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


1.5" TC 90 degree Elbow $18.00
Challenger Hop Pellets, 2 OZ $4.39
Swivel Flare Adapter - 1/4" FFL x 90 degree 1/4" OD hose barb $2.49
Brewbuilt X3 Glycol Jacketed 7 gallon Conical/Unitank Fermenter $1,199.99
Tungsten Carbide Hole Saw, 40mm or 1-5/8 Drill Bit, for Stainless Steel $19.00
Eclipse Hop Pellets (Australia), 2 oz $5.49
Carboy Calibration Decals $3.00
Pressure Gauge 0-30 PSI, Economy $10.00
Quick Disconnects (BLQD)Type B - FQD x MNPT $11.00