Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Quick Disconnects (BLQD)Type C 90 - FQD x 1/2" 90 Barb $14.99
Honey, Buckwheat, Five Pounds $35.19
Hex Nut (1/2" NPT/NPS) with hollow back for hose barb tailpieces. (This is NOT beer thread) $3.99
EVAbarrier keg beverage and gas tubing, 5mm ID X 8mm OD (13ft) $5.99
Omega Yeast HotHead Kviek OYL-057 (Omega Exclusive) 150mL Liquid Slurry $10.99
Simcoe Hop Pellets, OZ $2.26
Oregon Passionfruit Puree, 49oz Pouch $29.69
2 TC x 1" Female NPT Adapter $17.00
Nema L14-30P Twist Lock Cord Plug for 4-wire 240v, 30 amps $12.99