Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Nema 14-30P Cord Plug for 4-wire 240v, 30 amps $14.99
OETIKER Stepless Hose Clamp Crimping Tool $9.99
Omega GLUTEN FREE Lutra Kveik OYL-071 Dry Pack 11g $8.99
Keg Lube, 4 oz "Petro Gel" $5.99
Quick Disconnect (BLQD)s Type E - MQD x 1/2" Hose Barb $6.99
Add A Weldless Drain Bulkhead and Valve with Labor $45.00
Bevlex Thickwall PVC Tubing, 3/16" ID X 7/16" OD (per foot) $0.52
1.5" TC 45 FORTY-FIVE degree Elbow $15.00