Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-200 in increments of 5
Sight Calibration Decals 5-200 in increments of 5
 
Our Price: $8.00

Quantity in Stock:18

Product Code: CAL5-200
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Flare Washer, 1/4 Nylon $0.25
Motueka Hop Pellets, OZ $2.59
Mosaic Hop Pellets, 4 oz $6.99
3" TC PTFE Gasket (Heat Resistant to 400F) $3.50
CaraWheat, Weyermann LB $2.48
Din Rail, 12" Aluminum $4.25
Biofine Clear, aka (Silafine or Keiselsol) 4 fluid OZ (Vegan Fining Agent) $7.69
Chrome Plated Economy Beer Faucet $14.99
Bevlex Thickwall PVC Tubing, 3/8" ID X 5/8" OD (per foot) $0.82