Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


RIMS Hardware Kit 18" Body Length - 1/2" Male NPT I/O Ports $158.00
OETIKER Stepless Hose Clamp Crimping Tool $9.99
Pilsner Malt (HANA), Crisp SACK $108.90
1 Gallon Glass Jug with screw cap $6.99
Stainless Steel, NUKATAP, Forward Seal Faucet $33.99
Triclover Reducer 3" TC x 2" TC $19.99
Oktober Anytime (Octoberfest Lager) - 5 Gal All Grain Recipe Kit (Marzen Octoberfest) $26.40
Omega Yeast Gulo Ale OYL-501, 150ml Liquid Slurry $10.99
Munich Malt (Barke), Weyermann Sack $82.50