NPT Swivel Connector, Hexnut, 1/2" Female NPT/NPS x 1/4" Hose Barb

Home > Equipment > Fittings / Camlocks / Triclover > NPT Threaded Fittings >

Our Price: $6.99

Quantity in Stock:152

Product Code: NPTSWIVELHEXNUT14BARB

Qty:

Description

These Stainless Steel fittings are a hybrid between a traditional NPT fitting and a quick disconnect. The female NPT side is cut a little loose so it will fully thread on to any 1/2" male NPT or NPS fitting to allow the included captured silicone O-ring to seat and seal.

This particular fitting has a straight 1/4" hose barb on the other end which will accommodate 1/4" ID stiff hoses or even 3/16" ID as long as they are stretchy or can be heat softened.

Long story short, this is functionally the same as a 1/2 NPT female x 1/4" hose barb but instead of using teflon tape and needing to be tightened on with a wrench, this uses a gasket and can seal well hand tight. It is also more sanitary as your liquid will never touch the threads.

NOTE: This fitting looks A LOT like a tailpiece and beer nut setup that would normally thread on to Sanke keg couplers and faucet shanks (in fact the tailpiece is the same) but the nut is NOT beer thread.

Average Rating: Average Rating: 5 of 5

5 of 5 Total Reviews: 2 Click Here to Write a Review »

0 of 0 people found the following review helpful:

Perfect for Anvil Brew Bucket.	Saturday, April 27, 2024
Reviewer: Jamie McDougall from Quispamsis, NB Canada

Using this to keg beer from an Anvil Brew bucket. Works perfectly.

Was this review helpful to you?

0 of 0 people found the following review helpful:

Perfect fit	Friday, March 20, 2020
Reviewer: Robert McRae from Hinckley, OH United States

Came with washer and barb that fit the hose.

Was this review helpful to you?

	Spike Plus CENTER Pickup Tube (All Sizes) $44.00
	Megamouth Torpedo Keg Replacement LID with 1.5" TC port $64.99
	Glass Test Tube / Jar, 13" $11.99
	Stainless Steel False Bottom for Brew In a Bag (BIAB) - 18.75" Diameter $53.99