Diptube (High Flow) for Edge Pickup

Home > Equipment > Keg, Pot, Cooler Parts > Bulkheads >

Alternative Views:

Our Price: $17.00

Quantity in Stock:78

Product Code: DIPTUBE_EDGE

Qty:

Description

If you bought a pot with a welded coupling for the drain ball valve, installing this diptube on the inside will help you drain most of the liquid out and this new version will get amazingly close to the sidewall of the pot to avoid most of the trub (especially if you whirlpool).

Options:
The base item inclues the 5/8" OD tube bent at a 135 degree angle, the retaining nut with 1/2" Female NPT, and a sealing oring. You will select this unit if you have MALE threads on the inside of your kettle. This configuration will also work with our TrueBulkheadMale unit.

If your kettle has 1/2" FEMALE NPT threads on the inside YOU WILL ALSO NEED TO PURCHASE the Premium Hex Nipple as shown in the accessories on the right. It works best if your female threaded port is flush with the inside wall of the kettle. This gets the open end of the tube right in to the corner.

MAY NEED TRIMMING in some pots. The main picture shows the unit installed in a 15 gallon BrewBuilt pot (about 16" diameter) and it did not need trimming.

Note that the tubing portion of this diptube is really big. The OD is 5/8" and the ID is 9/16" for superior flow compared to all the other "maximizers" you find available.

If you need a replacement oring for this unit, it's the one listed as an accessory on the right.

Does it fit the Anvil Foundry? Yes it does. The picture below is in the 6.5 or 10.5 units but it also fits the 18.

Accessories

Hex Nipple, 1/2" NPT PREMIUM LOOSE

Silicone Oring, Replacement for BLQD

True Weldless Bulkhead - With 1/2" NPT Male Threads

Our Price: $5.99

Add

Our Price: $0.65

Add

Our Price: $18.00

Add