Sight Calibration Decals 5-140 in increments of 5

Home > Equipment > Vinyl Decals >

Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140

Qty:

Description

These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.

Instructions

- Your sight tubing must be dry and clean with no oils or dust.
- With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.
- Use a vertically applied length of masking tape on the sight tube as
- a straight edge and to have a place to mark the gallon levels.
- Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »

	The Sesh (Session Hazy Pale Ale) - 5 Gal All Grain Recipe Kit $29.00
	Intertap Faucet to Shank Gasket $0.75
	Omega Yeast LAGER 1, aka "BUDVAR", OYL-100 (similar to WY2000) 150ml Liquid Slurry $10.99