Home > Equipment > Kegging Parts >

1/4 Male FLARE (MFL) to 1/4" Hose Barb
1/4 Male FLARE (MFL) to 1/4" Hose Barb
 
Our Price: $2.89

Quantity in Stock:212

Product Code: FLARE14XBARB14
Qty:

Description
 
304 stainless steel with 1/4" Male Flare on one end and 1/4" barb on the other.

Accessories
Flare Washer, 1/4 Nylon
Our Price: $0.25

Add
Flare Washer, 1/4 Nylon

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 7 Click Here to Write a Review »

  0 of 0 people found the following review helpful:
 
5 of 5 Tuesday, April 26, 2022
Reviewer: Genius of beer and parts from Carlsbad, CA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Exactly what I needed Monday, March 9, 2020
Reviewer: Jeff Rieder from Cleves, OH United States  
I used this with a solid Fermonster lid to give me a port to connect CO2 for pressure transfers.  Worked great!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 A needed little pice Friday, May 10, 2019
Reviewer: Anonymous Person from Candor , NC United States  
I recently got a beer gun to replace a picnic tap. Unfortunately the beer gun is not available with a MFL fitting to attach it to the beer line so I was able to find this male threaded MFL fitting, and I used a short beer line between the beer gun barb and the male MFL barb. Connected to my existing beer line and it works great

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Great for using CO2 around the brewhouse Friday, March 2, 2018
Reviewer: Brian Maude from Calgary, AB Canada  
Purchased this to attach to the female fitting I have on an extra 5lb tank I use for purging kegs etc so I can easily switch between the hose barb or a QD.

I use the barb to push CO2 into a fermonster for closed transfers. Just drilled some small holes in a solid #10 bung. CO2 in, beer out via racking cane to keg. Works great!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Exactly what I needed - good quality, too. Sunday, September 24, 2017
Reviewer: Rob from NH United States  
Using a small piece of tubing, I attached this to the gas-in barb on my keg coupler so that it would work with my kegerator lines, which have swivel nuts on their ends.

Was this review helpful to you?

View All Customer Reviews


Keg Oring Kit, BUNA (Nitrile) Low Oxygen $3.75
Heat Shield small, for threaded in 1/2" NPT dial thermometers. $10.00
Apollo Hop Pellets, LB $23.10
4" TC Silicone Gasket (Heat Resistant to 400F) $3.99
Sight Calibration Decals 2-15 in increments of 1 $3.00
PBW, 10 LBs BULK BOX PBW Powdered Brewery Wash $59.99