NPT Swivel Connector, Hexnut, 1/2" Female NPT/NPS x 3/8" Hose Barb

Home > Equipment > Fittings / Camlocks / Triclover > NPT Threaded Fittings >

Our Price: $7.25

Quantity in Stock:148

Product Code: NPTSWIVELHEXNUT38BARB

Qty:

Description

These Stainless Steel fittings are a hybrid between a traditional NPT fitting and a quick disconnect. The female NPT side is cut a little loose so it will fully thread on to any 1/2" male NPT or NPS fitting to allow the included captured silicone O-ring to seat and seal.

This particular fitting has a straight 3/8" hose barb on the other end which will accommodate 3/8" ID stiff hoses or even 5/16" ID as long as they are stretchy or can be heat softened.

Long story short, this is functionally the same as a 1/2 NPT female x 3/8" hose barb but instead of using teflon tape and needing to be tightened on with a wrench, this uses a gasket and can seal well hand tight. It is also more sanitary as your liquid will never touch the threads.

NOTE: This fitting looks A LOT like a tailpiece and beer nut setup that would normally thread on to Sanke keg couplers and faucet shanks (in fact the tailpiece is the same) but the nut is NOT beer thread.

Accessories

Cool Touch Silicone Grip Sleeve for NPT swivel nuts

Our Price: $1.99

Add

Cool Touch Silicone Grip Sleeve for NPT swivel nuts

Share your knowledge of this product. Be the first to write a review »

	Flight of Apollo (West Coast IPA V2) - 5 Gal All Grain Recipe Kit $27.50
	Butterfly Valve, Squeeze Trigger, SS LIGHTWEIGHT, 1.5" TC ports $55.00
	Quick Disconnects (BLQD) Type D - FQD x FNPT $11.00
	Omega Yeast German Lager 1 OYL-106 (similar to wy2124 and WLP-830) 150ml Liquid Slurry $10.99
	Yeast a Practical Guide to Beer Fermentation Book $18.95
	SSbrewtech Unitank Carb Stone Ball Lock (free flow) QD UPGRADE $19.99
	Vintage Shop 3 Gallon PET Carboy Fermenter $19.50
	EZ Cap 500ml Amber Flip Top Bottles, Case of 12 $29.99
	Pressure Transfer Kit, Fermonster to Corny Keg (Build it Your Way) $18.00