Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Mighty Mill 3-roller Grain Mill, 3/8" Drive with Hand Crank and Hopper $239.00
Racking Cane, Stainless Steel, 1/2" OD Tubing, 23" Length $13.00
Cleaning Brush, 3/4" diameter $3.85
Spike 10gal Plus False Bottom (TC pickup tube) $137.50
1/4" MFL Male to 1/4" MFL Male Flare Coupling $3.00
Syringe, 10ml with 4" blunt tip needle $4.39
Five Star Sani-CLEAN (NOT STARSAN) 32 oz (Clear NOT purple) $21.99
SSbrewtech Unitank 2.0 Glycol Jacketed 14 gallon Conical/Unitank Fermenter $1,249.00
Saaz Hop Pellets, OZ $2.37