Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Push Fit Fitting Duotight - bulkhead 1/4" BSP x 5/16 Tube $4.99
Glass Carboy, 6.5 Gallons, Italian Made $59.00
Fermentis Safbrew Abbaye Dry Yeast BE-256 11.5 g $4.90
Brew Built 22g FB Silicone Edge Gasket $17.99
Saaz Hop Pellets, OZ $2.37
Stainless Oxygen (O2) Diffusion Stone - Barbed - Fine - 1/2 Micron for O2 $10.99
Coriander Seed (Indian), 8oz $6.99
Simcoe Hop Pellets, OZ $2.26