Sight Calibration Decals 5-300 in increments of 5

Home > Equipment > Vinyl Decals >

Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300

Qty:

Description

These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.

Instructions

- Your sight tubing must be dry and clean with no oils or dust.
- With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.
- Use a vertically applied length of masking tape on the sight tube as
- a straight edge and to have a place to mark the gallon levels.
- Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »

	Pressure Release Valve (PRV) Fixed 35psi, 1/4" NPT Thread $15.99
	Stainless Carbonation Cap TEE, PCO1881 Thread $8.99
	Wine Corks, #9 Aglica , 100 count $21.99
	1.5" Triclover (TC) to PCO1881 Male Thread Stainless Steel $9.99
	Candi Syrup, 2.5 LB JUG, D-45 Lovibond $20.89
	Silicone Tubing, Reinforced, by the foot, *1" ID x 1-1/4" OD (1/8" Thick Walls) $5.50**
	Quick Disconnects (BLQD) Type A - MQD x Female BSPP (Anvil Foundry, etc) $9.99
	Keg to Kettle Conversion Kit - Weld-On Drain Valve Only $40.00