Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Brew Built 15g FB Silicone Edge Gasket $13.49
Anvil Foundry System 6.5 Gallon Electric System $385.00
Pilsner Malt German, Avangard LB $1.91
Locline, 1/2" size, Single Straight Link $1.10
GUINNESS NITRO Dispenser Rental (local only) $64.99
Tubular "Bazooka" Screen (12" Long) with 1/2 MNPT $5.99
Silicone Tubing, Reinforced, by the foot, 1/2" ID x .80" OD (1/8" Thick Walls) $3.99
1.5" TC 45 FORTY-FIVE degree Elbow $15.00
Munich Dark (15L), Avangard Sack $71.50