Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-200 in increments of 5
Sight Calibration Decals 5-200 in increments of 5
 
Our Price: $8.00

Quantity in Stock:18

Product Code: CAL5-200
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Jarrylo Hop Pellets, OZ $2.92
Hex Nut (1/2" NPT/NPS) with hollow back for hose barb tailpieces. (This is NOT beer thread) $3.99
Fermonster 3 Gallon PET Widemouth PORTED Fermenter $25.50
1.5" Triclover (TC) to PCO1881 Male Thread Stainless Steel $9.99
1.5 TC x 1" Male NPT THREADS Adapter $14.00
1.5 TC to Male Beer Thread adapter $14.99
1/4 Male FLARE (MFL) TEE SPLITTER 304SS $5.99
Calcium Chloride 2oz $1.86
Quick Disconnects (BLQD)Type C 90 - FQD x 1/2" 90 Barb $14.99