Home > Equipment > Fittings / Camlocks / Triclover > NPT Threaded Fittings >

NPT Swivel Connector, Hexnut, 1/2" Female NPT/NPS x 1/4" Hose Barb
NPT Swivel Connector, Hexnut, 1/2" Female NPT/NPS x 1/4" Hose Barb
 
Our Price: $6.99

Quantity in Stock:152

Product Code: NPTSWIVELHEXNUT14BARB
Qty:

Description
 
These Stainless Steel fittings are a hybrid between a traditional NPT fitting and a quick disconnect. The female NPT side is cut a little loose so it will fully thread on to any 1/2" male NPT or NPS fitting to allow the included captured silicone O-ring to seat and seal.

This particular fitting has a straight 1/4" hose barb on the other end which will accommodate 1/4" ID stiff hoses or even 3/16" ID as long as they are stretchy or can be heat softened.

Long story short, this is functionally the same as a 1/2 NPT female x 1/4" hose barb but instead of using teflon tape and needing to be tightened on with a wrench, this uses a gasket and can seal well hand tight. It is also more sanitary as your liquid will never touch the threads.

NOTE: This fitting looks A LOT like a tailpiece and beer nut setup that would normally thread on to Sanke keg couplers and faucet shanks (in fact the tailpiece is the same) but the nut is NOT beer thread.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 2 Click Here to Write a Review »

  0 of 0 people found the following review helpful:
 
5 of 5 Perfect for Anvil Brew Bucket. Saturday, April 27, 2024
Reviewer: Jamie McDougall from Quispamsis, NB Canada  
Using this to keg beer from an Anvil Brew bucket. Works perfectly.



Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Perfect fit Friday, March 20, 2020
Reviewer: Robert McRae from Hinckley, OH United States  
Came with washer and barb that fit the hose.

Was this review helpful to you?



Omega Yeast OYL-004 West Coast Ale I (Compares to WLP-001 or WY1056) 150ml Liquid Slurry $10.99
Spike CF10 Temperature Control Coil $115.50
Citra Hop Pellets, OZ $2.74