Home > Equipment > Fittings / Camlocks / Triclover > Triclover >

52mm Socket Tool for Weldless 1.5" TC Bulkhead
52mm Socket Tool for Weldless 1.5" TC Bulkhead
 
Our Price: $15.00

Quantity in Stock:(Out of Stock)

Product Code: 52MMSOCKET
Qty:

Description
 
This is the right tool for the job when your locknut is 52mm

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 16 Click Here to Write a Review »

  0 of 0 people found the following review helpful:
 
5 of 5 Does what it needs to do Tuesday, April 16, 2024
Reviewer: Jake Jones from PEARLAND, TX United States  
Socket worked great for installing my weldless TC Port in the lid of my kettle.  Thanks for offering it here so I wasn't on a wild goose chase at the hardware store!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 52mm Socket Tool is worth it Wednesday, May 31, 2023
Reviewer: Bryan Miller from Pittsburgh, PA United States  
The tool makes installing the weldless bulkhead fittings just a bit easier.  Well with it considering what it costs.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Friday, December 31, 2021
Reviewer: Jim Sumrall from Thompsons Station, TN United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 Does what is says it does Thursday, December 10, 2020
Reviewer: Jason from WI  
It's a socket. It's the right size. It's inexpensive. It's exactly what it's describes as. If all you need it for is to install a TC bulkhead, just buy it. It works for it's intended purpose. You aren't going to find it cheaper somewhere else, and Bobby was nice enough to do all the research and source it for you. So buy the D**N socket now so you don't have to pay an additional $8 shipping just to get the socket when you realize later you really do need it. That's my friendly PSA for today.   : )

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 A must have for a tight fit Friday, October 30, 2020
Reviewer: JC from Quincy, MA United States  
This is by far the most economical socket you can purchase to secure a large 52mm nut onto a triclamp bulkhead fitting.  After looking around, I came back to Brewhardware and pulled the trigger.  It's well made, attached easily to my impact wrench and tightened down my connection with ease.  Great, affordable product - kudos again, BrewHardware!

Was this review helpful to you?

View All Customer Reviews


The Complete Meadmaker Book $16.95
Rubber Stopper, Drilled, #10.5 $2.25
3" TC EPDM Gasket (for cold side use) $1.99
SS Locknut, 1/2" NPS Pipe Thread with Large Flange $4.99
Hex Reducing Bushing - Multiple sizes available $2.00
Clip-On Trub Guard $10.00
Rubber Stopper, Solid, #6.5 $0.65
1.5 TC Clamp with welded M8 NUT $15.00