Home > Equipment > Fermentation >

Rubber Grommet for CANE, 3/8" ID x 11/16" Hole Size
Rubber Grommet for CANE, 3/8" ID x 11/16" Hole Size
 
Alternative Views:
Our Price: $1.75

Quantity in Stock:13

Product Code: GROMMETCANE
Qty:

Description
 
This grommet is sized for an 11/16" hole (or slightly smaller depending on how tight you want the 3/8" cane gripped). It will accommodate materials from 1/16 to 1/8" thick. In a fully relaxed state the interior hole is 3/8" which is what a smaller/standard racking cane measures. You CAN force a standard airlock into this hole though it will be very snug and may not fully insert. If this hole needs to be used for gas release, it would be better to shove a small scrap of 3/8" stainless or plastic tubing in, then attach a 5/16" or 3/8" ID hose onto that and drape it down into a container of starsan.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Click Here to Write a Review »

  1 of 1 people found the following review helpful:
 
5 of 5 Good product, 11/16" hole required Thursday, February 20, 2020
Reviewer: Daniel L. from Atlanta, GA United States  
This product works exactly as advertised, but I ended up using a step bit to drill out my fermenter lid to 11/16".  A 7/16" hole is too small to fit the whole piece through.

Was this review helpful to you?



Butterfly Hose Clamp, small for 7/16" to 9/16" OD tubing $1.10
CO2 Tank, FULL 5 LB Grade 1 Quality, NO SHIPPING $95.00
Wine Corks, #9 Economy micro-agglomerated cork , 100 count $14.99
Brew Built 50g FB Silicone Edge Gasket $22.99
Flat Silicone Gasket for 1/2" NPT, bulkheads, LTS sight kits, etc (13/16" ID x 1.25 OD) $1.45
Cable, 10/3 Cord with Nema L6-30R Twist Lock Cord Receptacle (approx 5ft) $29.99
Calcium Carbonate 2 oz $1.93
Azacca Hop Pellets, OZ $2.70
NPT Threaded Elbow, 90 Degrees, F/F $3.00