Home > Equipment > Fittings / Camlocks / Triclover > NPT Threaded Fittings >

NPT Swivel Connector, Hexnut, 1/2" Female NPT/NPS x 1/2" Hose Barb
NPT Swivel Connector, Hexnut, 1/2" Female NPT/NPS x 1/2" Hose Barb
 
Our Price: $7.99

Quantity in Stock:1622

Product Code: NPTSWIVELHEXNUT12BARB
Qty:

Description
 
These Stainless Steel fittings are a hybrid between a traditional NPT fitting and a quick disconnect. The female NPT side is cut a little loose so it will fully thread on to any 1/2" male NPT or NPS fitting to allow the included captured silicone O-ring to seat and seal.

This particular fitting has a straight 1/2" hose barb on the other end which will accommodate 1/2" ID stiff hoses or even 3/8" ID as long as they are stretchy like our 3/8" ID silicone tubing.

Long story short, this is functionally the same as a 1/2 NPT female x 1/2" hose barb but instead of using teflon tape and needing to be tightened on with a wrench, this uses a gasket and can seal well hand tight. It is also more sanitary as your liquid will never touch the threads.

NOTE: This fitting looks A LOT like a tailpiece and beer nut setup that would normally thread on to Sanke keg couplers and faucet shanks (in fact the tailpiece is the same) but the nut is NOT beer thread.

Accessories
Cool Touch Silicone Grip Sleeve for NPT swivel nuts
Our Price: $1.99

Add
Cool Touch Silicone Grip Sleeve for NPT swivel nuts

Share your knowledge of this product. Be the first to write a review »


Pull Through Solderable Bulkhead 1/2" M/M NPT $8.00
Brew Built 10g FB Silicone Edge Gasket $11.49
Brewzilla Heat Exchange Dish 65L (Gen 4) $28.99
Flaked Wheat LB $1.93
Caramunich 2, Weyermann OZ $0.15
BrewHardware Insulated Glycol Tubing Kit for Jacket Fermenters (TC PORTS) $159.00
Stainless Steel False Bottom for Brew In a Bag (BIAB) - 15.5" Diameter $45.99
Spike Spike Plus Shorty Pickup Tube $38.50
Cable, 10/3 Cord with Nema L6-30R Twist Lock Cord Receptacle (approx 5ft) $29.99