Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-200 in increments of 5
Sight Calibration Decals 5-200 in increments of 5
 
Our Price: $8.00

Quantity in Stock:18

Product Code: CAL5-200
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


1/2" NPT to 3/8" OD Tube Compression Elbow $15.00
Push Fit Fitting (duotight) - Beer Thread x 9.5mm XL XL XL (3/8") OD tubing $4.29
Hose Barb, 1/4" Male NPT x 3/8" Hose ID $3.00
Fermonster Lid Wrench $3.79
USED/FAIR 10 Gallon Electric Kettle - Dual 120v Elements 3300 watts total $200.00
1.5 TC x 1/2" Male NPT THREADS Adapter $12.00
Oxygenation Kit, Portable Cylinder Regulator, Economy Diffusion Wand $49.99
Spike Flow Pump 120V with 1.5" TC PORTS $320.00
Keg Low Profile Coupler SANKE American Beers (Type D) With Hose Barbs $37.99