 |
There are a lot of different kegerator line cleaning kits out there and they all suck. Boom roasted.
Seriously. Most of them are small containers with a big hand pump or glorified squeeze bottles and they require that you remove either the faucet or the keg coupler. Worst of all, they are overpriced.
Our DELUXE keg cleaning kit has the benefit of cleaning the coupler, the lines, and the faucet all in one step. The system features:
- Large 1-gallon tank with a long throw pressure hand pump.
- 4 ounce bottle of Beer Line Cleaner (BLC) concentrate (makes 2 gallons of diluted cleaner)
- 3/4" Diameter nylon cleaning brush for cleaning the coupler shaft and faucet spout.
- Stainless Steel machined CLEANING CAP to push cleaner up into your keg coupler from where the keg normally attaches (this is the primary difference with out DELUXE KIT).
THIS KIT WORKS FOR SANKE D (American Brands) and S couplers (Some European Brands) but not for Type A, G, or U couplers.
THIS VERSION (DELUXE) of our cleaning kit DOES NOT require that you remove the gas hose from the keg coupler. You just remove the keg coupler from your keg and attach it to our cleaning kit instead. SUPER EASY.
How it's used.- Untap the keg by unlatching the lever and moving it to the UP position. Remove the coupler from the keg
- Thread the connector from the cleaning tank hose onto the metal cleaning cap if it's not already connected from previous use. The connection should have a rubber gasket in place.
- Attach the keg coupler to the cleaning cap the same way you attach it to a keg. Insert and turn clockwise a quarter turn.
- Mix a half ounce of BLC concentrate with 1 quart of hot tap water in the pressure tank and screw on the lid.
- Pump the tank about 20 times to build up pressure.
- Place a bucket under the faucet, open the faucet, and until approximately 8 ounces of liquid pours into the bucket. This will first be old beer and then some of the cleaner.
- Close the faucet and allow the cleaner to soak in the line for 15-30 minutes depending on how soiled the line is.
- Open the faucet again until the remaining cleaner flushes through. You want to keep the flow pretty fast so pump it to build additional pressure if necessary.
- Use the brush to clean out the faucet spout and after temporarily removing the cleaning cap off the coupler, brush out the center tube a bit.
- Rinse and fill the tank to the one gallon mark with hot tap water and pump all of it through the line to rinse the cleaner out.
- Remove the cleaning cap and you're ready to tap your next keg.
|
|
|
Awesome Cleaner - Simple & Easy 
