Good for bulkheads, threaded nipples or ball valve
January 17, 2021
Reviewer:
TJ Ribeiro from Peekskill, NY United States
Clean threads, not nicks or hanging metal like you see from other online retailers. I used this to build a whirlpool setup and a spray ball recirc for my Anvil Foundry.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Helps to align the position of your ballvalve
September 20, 2020
Reviewer:
Rich W. from San Diego, CA United States
Nothing worse than threading on a ball valve only to have it sideways or upside down when it reaches the tightening portion of the threading. But with the locknut, you can thread that on first and make a stop point (jam nut) and get the angle of the ball valve where you want it.