Return to NPT Male, 1/2" Ball Lock Gas

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

It worked great September 8, 2025 Reviewer: Will Schmit from Albuquerque, NM United States   I have a strange project that requires the part to be pressurized.  CO2 was the answer -- I should have bought 2 Was this review helpful to you?

0 of 0 people found the following review helpful:

Counterflow chiller May 5, 2025 Reviewer: Randy Daily from La Porte, TX United States   Was needing something to blow water sitting in my counterflow chiller out. Attached this to a cam lock fitting. Works great! Was this review helpful to you?

0 of 0 people found the following review helpful:

April 19, 2024 Reviewer: Chris McGowen from Hillsboro, OR United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

NPT Male, 1/2" Ball Lock Gas June 30, 2023 Reviewer: Ben Kessler from Newberg, OR United States   Easy to install on fermenter lid. Sturdy piece. Was this review helpful to you?

2 of 2 people found the following review helpful:

The Missing Link January 13, 2019 Reviewer: PZ from New York, NY United States   I use this with a male QD (camlock type A) to push beer out of my ssbrewtech fermenter into a keg. At packaging, a gas QD clamps onto gas ball lock/ male camlock combo which is connected to a silicone hose with a female camlock at one end and a plain open hose at the other. I then set the regulator to 1-2 psi and move the beer without having to lift 60 pounds out of a chest freezer. Having this little gizmo means I don't have to set up a dedicated CO2 line. I also can use any of the hoses that I use on brew day. It's pretty amazing that a complicated task can be performed with ordinary gear... plus the missing link. Was this review helpful to you?

2 of 2 people found the following review helpful:

January 29, 2018 Reviewer: Francisco Ramos from Dulles, VA United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Hard to Find Part! September 24, 2017 Reviewer: Bryan from MN   This is a male 1/2" NPT to male keg post adapter. I have used them both on my heat exchanger, and now on a standard 10" water filter housing so I can connect my ball lock quick connects. Thanks for offering this- It is hard to find! Was this review helpful to you?