Return to True Weldless Bulkhead - With Edge Pickup Diptube

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

Great addition to BK September 26, 2022 Reviewer: Derek McLaren from Franklin, TN United States   This was the perfect addition to my boil kettle. Worked great for my last brew day. Left very little wort behind and allowed for whirlpool. Highly recommend. Was this review helpful to you?

0 of 0 people found the following review helpful:

Great fit August 23, 2020 Reviewer: Ben Wells from San Diego, CA United States   I put it on and tighten it up no leaks no runaway oring. The o ring is on the inside of the kettle so it won’t get scorched.   I am looking forward to my next brew. Was this review helpful to you?

0 of 0 people found the following review helpful:

It's big August 16, 2020 Reviewer: Wayne Smith from Manchester, NJ United States   The bulkhead installed easily.  I called BH to make sure I installed it correctly and Bobby helped me out.  The dip tube is solid and bigger than I thought.  Tight fit but should work perfectly. Was this review helpful to you?

0 of 0 people found the following review helpful:

Works perfectly May 16, 2020 Reviewer: Philip from Monroe, VA United States   No leaks! Was this review helpful to you?

0 of 0 people found the following review helpful:

Zero leaks, excellent hardware April 27, 2020 Reviewer: Sean from OH United States   I drilled two holes in my kettle (sourced elsewhere) for this and another fitting, both from BrewHardware. First try, neither leaked. Excited to try it out on a brew day! Was this review helpful to you?

1 of 1 people found the following review helpful:

A Thing of Beauty... January 13, 2019 Reviewer: PZ from New York, NY United States   ... and it works perfectly. I originally got this to go in my new water cooler mash tun, but was so beautiful that I had to move it to my boil kettle. It fits right up to the side of the pot, close enough that whole cone hops will not escape. As long as you tip the pot and don't lose the siphon it will drain almost to the last drop. The bulkhead itself was a revelation. I had been going through contortions (and lots of Teflon tape) to get my old setup to not leak. I barely had to tighten this one down and it worked. Every brew kettle deserves one of these bulkheads. Was this review helpful to you?