Return to Heating Element, Threaded, 1650 watt, 120v, All Stainless Steel

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 4

0 of 0 people found the following review helpful:

August 25, 2019 Reviewer: Adam Silver from Springfield, VA United States   Was this review helpful to you?

0 of 0 people found the following review helpful:

Perfect additions to my keggle November 1, 2018 Reviewer: David Tu from suffolk, VA United States   Got 4 heaters. 2 for boil kettle and 2 for HLT. Each element hooks up to separate 115 volt/ 15 amp outlets. Heated 10 gals of water from 69 F to boiling in less than 1 hour. The boil was pretty vigorous for 3300 total watts. Make sure to either clean the heaters before install or boil water for an hr to get the machine oil off the surface. Was this review helpful to you?

0 of 0 people found the following review helpful:

Great with ipb-16 with hot rod October 2, 2018 Reviewer: Tom F from Aurora, IL United States   The most powerful element you can run using inkbird ipb-16 controller.  Bonus that it’s also a ultra low wattage so you don’t have to worry about any scorching. Was this review helpful to you?

0 of 0 people found the following review helpful:

Excellent product May 1, 2017 Reviewer: andrew galvin from san francisco, CA United States   I burned out an element on accident and needed a replacement for my unibrau system. This thing did the trick! Highly Recommended. Was this review helpful to you?

0 of 0 people found the following review helpful:

Works April 26, 2017 Reviewer: Alexander Kaul from Terrace, BC Canada   Tried it out and works like a champ. Was this review helpful to you?

0 of 0 people found the following review helpful:

It Does what I need it to. February 16, 2017 Reviewer: Grey Dziuba from Rome, GA United States   I never had to worry about boil over with the grainfather, but I do now. Was this review helpful to you?

0 of 0 people found the following review helpful:

strike and tun water heating October 6, 2016 Reviewer: Donald Schubert from Vernon, CT United States   guidance by Brewardware was great for retrofitting two old kettles for these uses! Was this review helpful to you?

1 of 1 people found the following review helpful:

exactly as described September 16, 2016 Reviewer: Austin K. from Coon Rapids, MN United States   Bought this element for a RIMS system and because it is an all stainless element. Works great, could not be happier. Thanks brewhardware for the fast shipping and excellent service. Was this review helpful to you?

1 of 1 people found the following review helpful:

Heating element review August 22, 2016 Reviewer: Anonymous Person from Annapolis, MD United States   Product arrived very quickly. I was able to install the new element into my 10 gallon kettle with out any issues. Brewed a 6 gallon batch the same weekend. Didn't have any issues bring the strike water or wort to temp. No problem with scorching either. Very pleased. Would recommend and buy again. Was this review helpful to you?

0 of 0 people found the following review helpful:

Very Good March 6, 2016 Reviewer: Joe from Lakewood, CO United States   The stainless steel heating elements work very good for my application. I was having a lot of problems with rust and that took care of it. Got them quick. Thank you Was this review helpful to you?