SS Locknut (NPS) - 1/2" NPT

Home >

Our Price: $4.00

Quantity in Stock:1718

Product Code: LOCKNUT_12

Qty:

Description

These 304SS locknuts have NPS straight thread so they will thread all the way down the threads of any NPT fitting. One side is flat and the other has a machined O-ring groove. Available in 1/4", 1/2" and 1" NPS sizes.

This 1/2" NPS size is found out a ton of our other assemblies from the SpinCycle to the True Weldless Bulkheads.

You can get these separately here, but they are also included in the thermometer "make weldless" kits which an easier way to order if you need a gasket and washer also.

Average Rating: Average Rating: 5 of 5

5 of 5 Total Reviews: 2 Click Here to Write a Review »

0 of 0 people found the following review helpful:

Good for bulkheads, threaded nipples or ball valve	January 17, 2021
Reviewer: TJ Ribeiro from Peekskill, NY United States

Clean threads, not nicks or hanging metal like you see from other online retailers.
I used this to build a whirlpool setup and a spray ball recirc for my Anvil Foundry.

Was this review helpful to you?

0 of 0 people found the following review helpful:

Helps to align the position of your ballvalve	September 20, 2020
Reviewer: Rich W. from San Diego, CA United States

Nothing worse than threading on a ball valve only to have it sideways or upside down when it reaches the tightening portion of the threading. But with the locknut, you can thread that on first and make a stop point (jam nut) and get the angle of the ball valve where you want it.

Was this review helpful to you?

	Weldless Large Sightglass Kit, LTSK For Kegs, NO Thermometer $28.00
	Fermfast Copper Mesh Reflux Still Packing 20ft Roll $18.99
	4" TC Medium Weld Ferrule $12.99
	3 WAY 1/2" NPT BALL VALVE - T Flow 3way 3-way $39.00
	Rubber Stopper, Solid, #10.5 $2.25
	Push Fit Fitting (duotight) - Beer Thread x 8mm (5/16") OD tubing $4.29
	1/2" NPS Continuous Threaded Nipple 2.5" LONG $7.00
	How to Brew Book 2017 $18.00
	Hose-End Sprayer/Aerator $3.25