Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


EnPrimeur Winery Series Chilean Carmenere $174.90
Pectic Enzyme 1/2 oz liquid for Fruit Wine and Cider $3.29
Cable, 15ft 10/3 Cord with NEMA L6-30P Locking Plug $31.00
Keg Lube, 4 oz "Petro Gel" $5.99
1.5" Triclover to 1/4" MFL (male flare) adapter $10.00
Brew Built 15g FB Silicone Edge Gasket $13.49
Carafoam, Weyermann OZ $0.17
SSbrewtech Unitank Carb Stone Ball Lock (free flow) QD UPGRADE $19.99
24" Steel Mash Paddle $12.99