Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


CO2 Manifold 3-way Splitter - MFL I/O BH $31.99
Sanke Coupler Parts - Gas Input Check Valve aka Duckbill $2.25
Corny Keg, Ball Lock, 5 gallon, Used Grade A $59.00
Blichmann Weldless Plug Assembly(1/2" actual hole measurment) $9.00
Wine Bottle Brush $3.99
Carboy Dryer $11.00
Hose Barb, 1/2" Male NPT x 5/8" Hose ID $4.00
Carboy Brush $7.75
Hose Barb, 1/2" Female NPT x 1/2" Hose ID $4.00