Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Ball Lock Keg Disconnect ALL STAINLESS - Beer Side - Male Flare MFL $16.99
White Wheat Malt, Rahr or Briess OZ $0.10
Duotight 0-30psi Replacement Pressure Gauge $6.25
Biofine Clear, aka (Silafine or Keiselsol) 16 fluid oz (Vegan Fining Agent) $20.89
Warrior Hop Pellets, OZ $2.42
Liquid Side Ball Lock Keg Post (9/16"-18) with Universal Poppet $7.25
1" TC Instrument TEE $19.00
Epsom Salts (Magnesium Sulfate) 2oz bag $1.64
Crystal 120L (Caramel Malt), Briess LB $2.48