Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-140 in increments of 5
Sight Calibration Decals 5-140 in increments of 5
 
Our Price: $5.00

Quantity in Stock:70

Product Code: CAL5-140
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Blowoff Hose with Elbow Fitting $2.75
Citra Hop Pellets, 8oz $16.49
Priming Sugar Corn Sugar Dextrose 1 oz $0.28
Omega Yeast OYL-012 Pacific Northwest Ale (Compares to WY1332 or WLP041) 150ml Liquid Slurry $10.99
Portuguese Floor Corker $69.00
Beverage Hose - EVA Tubing, Duotight Pin Lock QD to Faucet Shanks $14.99
Silicone Tubing, Reinforced, by the foot, 1/2" ID x .80" OD (1/8" Thick Walls) $3.99
RIMS Hardware Kit 12" Body Length - 1/2" Male NPT I/O Ports $149.00
Sight Calibration Decals 5-60 in increments of 5 $3.00