Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-300 in increments of 5
Sight Calibration Decals 5-300 in increments of 5
 
Our Price: $9.00

Quantity in Stock:6

Product Code: CAL5-300
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Beech Smoked, Weyermann OZ $0.14
1.5 TC x 5/8" Hose Barb 90 Elbow $15.99
Epsom Salts (Magnesium Sulfate) 2oz bag $1.64
Omega Yeast German Lager 1 OYL-106 (similar to wy2124 and WLP-830) 150ml Liquid Slurry $10.99
RIMS Hardware Kit 12" Body Length - 1/2" Male NPT I/O Ports $149.00
NPT Swivel Connector, Hexnut, 1/2" Female NPT x 5/8" Hose Barb $8.99
EZ Cap 500ml Amber Flip Top Bottles, Case of 12 $29.00
Silicone Tubing by the foot, 1/4" ID x 3/8" OD (3/32" Thick Walls) PER FOOT $1.49
1.5 TC EPDM Gasket with 10 Mesh Screen $7.99