Home > Equipment > Fermentation >

Rubber Grommet for CANE, 3/8" ID x 11/16" Hole Size
Rubber Grommet for CANE, 3/8" ID x 11/16" Hole Size
 
Alternative Views:
Our Price: $1.75

Quantity in Stock:13

Product Code: GROMMETCANE
Qty:

Description
 
This grommet is sized for an 11/16" hole (or slightly smaller depending on how tight you want the 3/8" cane gripped). It will accommodate materials from 1/16 to 1/8" thick. In a fully relaxed state the interior hole is 3/8" which is what a smaller/standard racking cane measures. You CAN force a standard airlock into this hole though it will be very snug and may not fully insert. If this hole needs to be used for gas release, it would be better to shove a small scrap of 3/8" stainless or plastic tubing in, then attach a 5/16" or 3/8" ID hose onto that and drape it down into a container of starsan.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Click Here to Write a Review »

  1 of 1 people found the following review helpful:
 
5 of 5 Good product, 11/16" hole required February 20, 2020
Reviewer: Daniel L. from Atlanta, GA United States  
This product works exactly as advertised, but I ended up using a step bit to drill out my fermenter lid to 11/16".  A 7/16" hole is too small to fit the whole piece through.

Was this review helpful to you?



Pressure Release Valve (PRV) Fixed 35psi, 1/4" NPT Thread $15.99
Kegmenter Pressure Lid with 2" TC port $13.99
1" TC Instrument TEE $19.00
Flaked Corn (Maize) LB $2.20
Nema 14-50P Cord Plug for 4-wire 240v, 50 amps $15.99
1/2" or 3/4" TC Silicone Gasket (Heat Resistant to 400F) $1.00
Quick Disconnects (BLQD) - FQD x 3/8" Compression $17.00
Beer Gas Tank, FULL 22cuft with 75/25 Beer Gas, NO SHIPPING $149.00
White Wheat Malt, Rahr or Briess OZ $0.10