Home > Equipment > Vinyl Decals >

Sight Calibration Decals 5-200 in increments of 5
Sight Calibration Decals 5-200 in increments of 5
 
Our Price: $8.00

Quantity in Stock:18

Product Code: CAL5-200
Qty:

  
Description
 
These were custom made for a few nano breweries in the past so we decided to offer them up as a standard product. These numbers are slightly larger than our standard 2-15 decals because we assume the area they will be stuck to is a little larger.

The numbers and arrows are exactly 1/2" tall. The two-digit numbers including the arrow are 3/4" wide and then it goes up to about 1-1/4" after the 100. If this is too wide, you could always apply the arrows at the calibration locations and stack the label number under or over the arrow.
Instructions
    • Your sight tubing must be dry and clean with no oils or dust.
    • With the clear plastic top masking still in place, cut each number squarely off the strip at the left edge of the number/arrow.


    • Use a vertically applied length of masking tape on the sight tube as
    • a straight edge and to have a place to mark the gallon levels.
    • Skip to the 11 minute mark in the video to see how the decals are to be applied.

Share your knowledge of this product. Be the first to write a review »


Glycol Chiller, SSbrewtech 1/5HP $999.00
Swivel Flare Adapter - 3/8" FFL (UNCOMMON) x 3/8" OD hose barb $4.99
Stainless Oxygen (O2) .5 Micron Diffusion Stone with 1/4" MFL $11.99
1.5" Triclover to 1/4" MFL (male flare) adapter $10.00
CLEARANCE Lallemand Lalbrew NOVA Lager Dry Yeast 11 gram $0.50
Duotight Flow Stopper Automatic Keg Filler $14.99
Fermonster 3 Gallon PET Widemouth PORTED Fermenter $25.50
8-way CO2 Distribution Manifold Splitter with Male Flare $39.00
Pinlock MFL Liquid/Beer Disconnect (CMB) $4.75