Tungsten Carbide Hole Saw, 48mm Stainless Steel

Home > Equipment > Tools / Accessories >

Our Price: $19.00

Quantity in Stock:17

Product Code: HOLESAW48

Qty:

Description

Our step bits are great for drilling a bunch of different hole sizes, but you do have to drill for a while because you're making a bunch of holes, larger and larger. These new Tungsten Carbide tipped hole saws make fast work through stainless. The only downside is that you need a different bit for every hole size. If you are going to drill several holes of the same size, you'll appreciate the speed and durability of these types of bits.

This 48 mm bit is also equivalent to 1-7/8" which is appropriate for installing our 2" weld ferrules with the pull through tool on thicker walled vessels. You'll need a slow speed, high torque drill motor for these with a 1/2" or larger chuck. It is highly recommended that you start ANY size hole with a smaller pilot bit approximately 1/8" and drill a couple test holes in scrap metal to get the hang of using these bits. They cut aggressively and you will need to learn the appropriate amount of downforce and speed to use. When the cut is nearing completion, the drill will have a tendency to buck on you so make sure the pot and the drill are being held firmly. An extra set of hands is recommended. Everyone in the area should be wearing eye protection.

Apply cutting oil to the area before drilling or at the very least use ANY oil you have access to.

NOTE: These bits are recommended for users that have a reasonable/intermediate level of DIY experience with power tools and/or metal working in general. Keep in mind that when the larger hole boring section of this bit hits your pot wall, it is going to cause your drill motor to kick in your hands. Do not attempt to hold the drill with one hand. Firmly grip your drill with both hands and prop the handle against your leg and tense up for additional stability. If the drill bit binds at all and causes the drill to kick and you do not secure it, you will likely break one or more of the carbide tips off of the bit. We will NOT replace a drill bit with broken tips because it does not represent a defect in workmanship. You've heard a lot about using the right tool for the job, but this is one of those cases where we have to stress having a certain ability for the tool. This is especially true for the 32mm size and UP.

Share your knowledge of this product. Be the first to write a review »

	Abstrax - Quantum Hop Extracts 5ml- NRN Nectaron $16.49
	Flavoring, Natural, Passionfruit, 4oz $4.79
	Temp Controller, 240V/50a Brew Buddy II, DIY KIT $999.00
	Homebrew Decals - "Eat Sleep Brew" $2.00
	Spike Clear Cap $27.50
	Cable, 14/3 with molded 5-15P plug, 6 feet $12.99
	Grains of Paradise, 2 grams $3.30
	Wine Expert Private Reserve Italian Amarone w/skins 14L Wine Kit $179.00
	Heating Element, FOLDBACK, 3500 Watt 240V, 1.5" TC INTEGRATED ULWD $79.00