Rubber Grommet for CANE, 3/8" ID x 11/16" Hole Size

Home > Equipment > Fermentation >

Alternative Views:

Our Price: $1.75

Quantity in Stock:13

Product Code: GROMMETCANE

Qty:

Description

This grommet is sized for an 11/16" hole (or slightly smaller depending on how tight you want the 3/8" cane gripped). It will accommodate materials from 1/16 to 1/8" thick. In a fully relaxed state the interior hole is 3/8" which is what a smaller/standard racking cane measures. You CAN force a standard airlock into this hole though it will be very snug and may not fully insert. If this hole needs to be used for gas release, it would be better to shove a small scrap of 3/8" stainless or plastic tubing in, then attach a 5/16" or 3/8" ID hose onto that and drape it down into a container of starsan.

Average Rating: Average Rating: 5 of 5

5 of 5 Total Reviews: 1 Click Here to Write a Review »

1 of 1 people found the following review helpful:

Good product, 11/16" hole required	February 20, 2020
Reviewer: Daniel L. from Atlanta, GA United States

This product works exactly as advertised, but I ended up using a step bit to drill out my fermenter lid to 11/16". A 7/16" hole is too small to fit the whole piece through.

Was this review helpful to you?

	Hop Bong Dry Hopper Kit - 1.5" TC $39.99
	Cable, 10/4 Cord (4ft) with Nema 14-30P Male Plug $31.99
	HotRod Heat Stick, 240 VOLT 5500 watt Ready to Use $169.00
	CO2 Hose - Bevlex Tubing, Beer Thread Tailpiece to Open End (for barbs) $5.99
	1.5 TC x FEMALE GARDEN HOSE (GHT) $13.00
	LalBrew Voss Kveik Ale Dry Yeast - Lallemand $4.94
	RIMS Hardware Kit 12" Body Length - 1/2" Male NPT I/O Ports $149.00
	Bru-1 Hop Pellets, LB $25.30