Make Weldless Kit 1/2" NPT for COOLERs

Home > Equipment > Keg, Pot, Cooler Parts >

Our Price: $8.00

Quantity in Stock:14

Product Code: MWL12COOLER

Qty:

Description

If you want to install a dial thermometer in a double wall cooler, you'll need an extended bulkhead like these. Here's how they work: The dial thermometer threads directly into the open end of the coupling. The coupling extends through the outside wall and insulation of the cooler and then the weldless bushing/gasket seals to the interior wall of the cooler. This 1/2" NPT version requires a 1-1/8" hole in the outside wall of the cooler and a 13/16" hole in the interior wall. The weldless bushing piece in this assembly is custom machined just for us so this isn't something that can be easily made from "off the shelf" parts.

Keep in mind that this bulkhead is NOT meant for draining liquid out of your cooler.

The picture below shows the application of this bulkhead for use with a dial thermometer. The picture shows both available sizes.

Average Rating: Average Rating: 5 of 5

5 of 5 Total Reviews: 5 Click Here to Write a Review »

0 of 0 people found the following review helpful:

Works great in my chest cooler!	March 15, 2020
Reviewer: Clark from Paicines, CA United States

I used this to install a 6 inch stem thermometer in my mash tun cooler. It works great-easy to install, no leaks. I installed the thermometer first before placing in the cooler. Just follow the instructions and drill carefully. I used Forstner bits for inside and outside holes.

Was this review helpful to you?

0 of 0 people found the following review helpful:

	June 17, 2018
Reviewer: Brian Nichols from fraser, CO United States

Was this review helpful to you?

0 of 1 people found the following review helpful:

works great	December 11, 2016
Reviewer: Chris from SoCal

the gasket has to be placed on the outside of the inner wall

Was this review helpful to you?

0 of 0 people found the following review helpful:

Excellent fit	November 16, 2014
Reviewer: Anonymous Person from havertown, PA United States

Fit my 10 gallon Igloo cooler perfectly. I added a larger washer as the supplied one seemed a little small.

Was this review helpful to you?

0 of 0 people found the following review helpful:

It works	November 14, 2014
Reviewer: Eric Carpenter from San Jose, CA United States

Works great on my red Rubbermaid 10 gallon mash tun.

Was this review helpful to you?

	Misc dollar charge $1.00
	Sulphur Strips for Barrel Sanitizing $5.49
	Spike Flex TC100 Bundle no Heater $357.50
	Add A Weldless Drain Bulkhead and Valve with Labor $45.00
	Sanke Coupler Parts - Gas Input Check Valve aka Duckbill $2.25