Home > Equipment > Fittings / Camlocks / Triclover > Triclover >

Triclover Reducer, 4" TC x 1.5" TC with Ball Lock Ports and PRV
Triclover Reducer, 4" TC x 1.5" TC with Ball Lock Ports and PRV
 
Our Price: $49.00

Quantity in Stock:(Out of Stock)

Product Code: TC4X15OFFSET_BALLLOCK
Qty:

Description
 
4" Triclover (TC) cap with a 1.5" TC ferrule welded offset to the side as much as possible. Measures 4.5" x 2"diameter actual flange diameters. 304 SS.

The assembly also has gas and liquid ball lock keg posts with a floating diptube as well as a 17psi venting pressure relief valve with a manual vent pull ring. The soft silicone floating diptube is long enough to reach the bottom of a half barrel keg.

Essentially this adds functionality to any vessel that has a 4" TC port on the top such as Conical fermenters, Brite tanks, or Kegmenters.

IT IS EXTREMELY DANGEROUS TO LOOSEN THE 4" or 1.5" TC CLAMP WHILE THERE IS EVEN A LITTLE BIT OF PRESSURE REMAINING IN THE VESSEL. BEST PRACTICE DICTATES THAT YOU VENT AND FULLY REMOVE THE PRV FROM THE ASSEMBLY BEFORE LOOSENING ANY TC CLAMPS !!!!!

Accessories
4" TC Silicone Gasket (Heat Resistant to 400F) 4in TC Clamp
Our Price: $3.99

Add
Our Price: $12.25

Add
4" TC Silicone Gasket (Heat Resistant to 400F) 4in TC Clamp

Share your knowledge of this product. Be the first to write a review »


NPT Male, 1/2" Ball Lock Gas $14.99
Hex Beer Thread Cap $3.95