 |
If you have an all in one system with the pump and it has a rigid tube that ends in a female camlock, this whirlpool is compatible. Chilling times are greatly reduced if you keep the wort stirring while using an immersion wort chiller. You could do it with a spoon but since you already have a pump, dropping in this retrofit whirlpool will do the job for you while you kick back with a beer.
We simply TIG welded a male camlock to some custom bent 3/8" OD SS tubing that goes up, over, and then down to about the 3 gallon mark on most 35 liter or 9-10 gallon all in ones such as BrewZilla, Vevor, etc.
From the sealing surface of the male camlock, the bottom outlet is about 15" lower. We can customise by request an inch or so plus or minus without any extra charge.
You're just getting a bent 3/8" OD 304 SS tube with a welded male camlock on it. No brewing system, valve or female camlocks included despite being in the picture. Can you imagine? A whole brewing system for less than 30 bucks?
|
|
|
Can use with grainfather 
Does not fit my Robobrew V3 
