Home > Equipment > Keg, Pot, Cooler Parts > Valves >

Ball Valve (EZ Clean) with 1.5" TC ports
Ball Valve (EZ Clean) with 1.5" TC ports


 
Our Price: $42.00

Quantity in Stock:8

Product Code: TC15_2PBV_EZ
Qty:

Description
 
This 304 stainless steel ball valve has 1" / 1.5" TC flanges on both ends and is built in two main pieces. The valve can be taken apart just by loosening the large TC clamp in the center. You will gain access to the seals, ball and main valve cavity for fast cleaning which is key for any cold size operation or fermenter. The bore is exactly 5/8" which is fine for most drain applications. If you need a bigger bore such as for use in a conical dump, we also have 1.5" butterfly valves available.

VERY IMPORTANT NOTE. Though this valve comes apart by hand via a central TC clamp, by design it is still a ball valve that seals due to being squeezed between two PTFE seats. These seats get "lapped in" to a particular valve. When you take this valve apart for cleaning, you must either leave the PTFE seats in place or keep each of their install locations straight. That is, do not swap the positions of the seats. It is even more important not to swap seats between different valves. If you do swap positions or valves, you are likely to encounter slow leaks or at the very least have to crank down on the central TC valve much harder.
Average Rating: Average Rating: 4 of 5 4 of 5 Total Reviews: 4 Click Here to Write a Review »

Accessories
Cleaning Brush, 3/4" diameter
Our Price: $3.85

Add
Cleaning Brush, 3/4" diameter
Heat Shield Large sideways clip for Ball Valves
Our Price: $10.00

Add
Heat Shield Large sideways clip for Ball Valves


  1 of 1 people found the following review helpful:
 
1 of 5 Leaks no matter what I do September 26, 2020
Reviewer: Michael Mahlum from Boise, ID United States  
I cannot get these to stop leaking, waste of money. I have other tri-clamp ball valves from a  different company that work very well. I do not recommend these ones.

BrewHardware.com Response: It sounds like you have a defective PTFE seal in the valve/valves. Upon further look, you ordered two valves a year and a half ago and the seats usually set in to a particular valve. If you took both apart and swapped the seats between valves, it can cause leaks. Being that they are a year and a half old, we also have no way of knowing if they were exposed to heat or long soaks in PBW or Star San which can damage PTFE.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 EZ clean T/C ball valves October 20, 2019
Reviewer: Tom Paffrath from Salisbury, NC United States  
Great Valves , clean out cap on bottom a plus. 2 piece easy to clean. Too bad they aren't made in the USA !

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Excellent Value January 1, 2018
Reviewer: Scott S. from Covington, LA United States  
High quality valve at a good price

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Awesomeness July 10, 2017
Reviewer: Ian Shedlock from Brodheadsville, PA United States  
These are great value and the best way to go for keeping everything clean

Was this review helpful to you?